Panametrics Sentinel, User Manual, Page: 129 / 166

Sentinel™ User’s Manual 129
Appendix A. CE Mark Compliance
Appendix A. CE Mark Compliance
A.1 Introduction
For CE Mark compliance, the Sentinel Flow Measurement System must be wired in accordance with the instructions in
this appendix.
IMPORTANT: CE Mark compliance is required for all units intended for use in EU countries.
A.2 Wiring
The Sentinel must be wired with the recommended cable, and all connections must be properly shielded and
grounded. Refer to Table 3 below for the specific requirements.
Note: If the Sentinel is wired as described in this appendix, the system will comply with the EMC Directive.
Table 1: Wiring Modifications
Connection Cable Type Termination Modification
Input/Output 22 AWG shielded
(e.g., Baystate #78-1197)
Terminate shield
to chassis ground.
Armored conduit None - grounded
using a conduit fitting.
Power 14 AWG, 3 conductor, shielded
(e.g., Belden #19364)
Terminate shield
to chassis ground.
Armored Conduit None - grounded
using a conduit fitting.