Panametrics Sentinel, User Manual, Page: 103 / 166

Sentinel™ User’s Manual 103
Chapter 6. Transducer Replacement
6.3.2 T11 Transducer Installation Components
See Table 1 below and Figure 75 below for the components required to install the new transducer.
Figure 2: T11 Installation Components for a Depressurized Pipe
6.3.3 Installing a New Transducer in a Depressurized Pipe
IMPORTANT: The following procedures should be used only in situations where the process line is shut down.
Table 1: Components at each Transducer Location
No.* Part Number Description Qty.
1 577-004-00 Sensor Holder 1
2 551-1135 Sensor Flange 1
3 410-538 O-Ring, Size 210, Viton 2
4 410-539 O-Ring, Size 213, Viton 1
5 412-1032-24 Screw, Cap Hex 3/8-16 x 1-1/2 4
6 412-148 Washer, Lock Split 3/8” 4
7 O-Ring-Safe Lubricant A/R
8 Anti-Seize Lubricant A/R
*Component numbers correspond to item numbers in Figure 75 below.
T11 Transducer
1
3
2 places
4
2
6 5
4 places
7
7
8
4 places