Panametrics HydroProII, User Manual

Page: 90 / 104

Appendix B. HygroPro
II
Field Service Update User Manual
78 HygroPro
II
User's Manual
B.1.3 Software Setup
1. Make sure the drivers for your RS485 to USB Adapter are installed
2. Start the Tera Term Application
3. The New Connection Menu will open
a. Select “Serial”
b. Select the USB to RS485 adapter from the drop-down menu (It will be labeled “USB Serial Port”)
Figure 22: Select Serial Connection
4. Set the correct settings for the serial terminal
a. From the menu at the top of the window select “Setup” > “Serial Port…”
b. Set the settings as shown below
i. PORT: This does not need to be changed
ii. Baud rate: 9600
iii. Data: 8 bit
iv. Parity: none
v. Stop: 1 bit
vi. Flow Control: none
vii. Transmit Delay 0,0
c. Click “OK”