Panametrics GF868, Programming Manual, Page: 95 / 167

12/1/99
3-2 Logging Data
The STD Sub-Menu
Use the STD sub-menu to create a new standard log and to select the
parameters to log, the log start time and date, the log end time and
date, and the time increment. Also, any log file already stored in
memory may be inspected and/or changed.
Press the appropriate side of the [SCREEN] key to activate the desired
pane of the display screen, and refer to Figure A-7 on page A-7 of
Appendix A, Menu Maps while completing the following steps:
Note: At the
NAME
prompt, the option bar will show the names of all
completed or active log files that are currently stored in
memory. Recall that a flashing asterisk (*) appears at the far
right of the locator bar if the Model GF868 is currently
logging data (see Chapter 3, Operation, of the Startup Guide).
Ch1 Channel Label site file
É
The default power up screen is in
BIG
mode. Access the Log Menu
by pressing the
[LOG]
key.
Velocity Ft/s
6.95
(error codes appear here)
VEL VOLUM +TOTL -TOTL
OPEN Start
Enter the assigned password and
press
[ENT]
. If the security
feature has been deactivated, this
prompt does not appear. See
Chapter 1, Programming Site
Data, for details.
ENTER PASSWORD
Password
LOG Start Press
[F1]
to select the
STD
option.
LOGGING
previous selection appears here
STD MEM STOP ERROR
NAME,MESSAGE,etc.
É
Use the [
←]
, [
→]
and
[F1]-[F4]
keys to inspect a completed log
or to change an active log, or
enter a new name (up to 5
characters) and press
[ENT] to
create a new log file.
LOGGING
Standard Log
NAME
previous selection appears here
LOG1 LOG2 LOG3 LOG4