DigitalFlow™ XMT868i Programming Manual
31
Chapter 1. Programming Site Data
1.4.2.2
Setting Up Option Cards (cont.)
Option Card Analog Inputs
Complete the following steps to set up the analog inputs of an option card installed in
Slot 1
(refer to Figure 32 on
1.
Scroll to the desired
Input
(
A, B, C
or
D
) and press
[Enter]
.
Note:
The setup of
Input A
is used as an example. Identical procedures would be used to set up the remaining
inputs.
2.
Enter a
Label
of up to eight characters for input A and press
[Enter]
.
3.
Scroll to
Off
to disable
Input A
and return to step 1, or on
Temp
or
Spec
to designate it as a temperature or special
input, and press
[Enter]
.
•
OFF
If
OFF
was selected to disable input A, the meter returns to the
Input
prompt in step 1. Scroll to another input, or press
[Escape]
to move to another menu.
•
TEMP
If
TEMP
was selected to set up input A as a live temperature input, complete steps 4 and 5 below:
4.
Enter a temperature value for the
Base
(low) end of the analog input range and press
[Enter]
.
5.
Enter a temperature value for the
Full Scale
(high) end of the analog input range and press
[Enter]
.
After responding to the above prompt, the meter returns to step 1. Press
[Escape]
to proceed to another menu or
option.
•
SPEC
If
SPEC
was selected to set up
Input A
as a live special input, complete steps 6 through 10 below:
6.
Enter a
Name
for input A and press
[Enter]
.
7.
Enter the
Units
of measurement for
Input A
and press
[Enter]
.
8.
Enter a value for the
Base
(low) end of the analog input range and press
[Enter]
.
9.
Enter a value for the
Full Scale
(high) end of the analog input range and press
[Enter]
.
After responding to the above prompt, the meter returns to step 1. Press
[Escape]
to proceed to another menu or
option.
Summary of Contents for DigitalFlow XMT868i
