Panametrics DigitalFlow XGF868i, Startup Manual

Page: 39 / 90

DigitalFlow™ XGF868i Startup Guide 29
Chapter 2. Initial Setup
2.4.1.1 Selecting Volumetric Units
1. Scroll to the desired Volumetric Units for the flow rate display and press
[Enter]
. Table 5 below lists the available
volumetric units.
2. Scroll to the desired unit of Volumetric Time (from seconds to days), and press
[Enter] .
3. Scroll to the desired number of Vol Decimal Digits (digits to the right of the decimal point) in the volumetric flow
display, and press
[Enter]
.
2.4.1.2 Selecting Totalizer Units
4. Scroll to the desired Totalizer Units for the flow rate display and press
[Enter]
. Available units are listed in Table 5
above.
5. Scroll to the desired number of Tot Decimal Digits (digits to the right of the decimal point in the totalized flow rate
display) and press
[Enter]
.
6. Do one of the following:
• If MASS FLOW is ON, proceed to Selecting Mass Flow Units on page 30 .
• If MASS FLOW is OFF, the meter returns to the
Global PROGRAM
window. Press
[Escape]
twice and proceed to
Chapter 3, Operation , or the Programming Manual .
Note: To activate mass flow, see Activating Mass Flow in Chapter 1 of the Programming Manual . The following
prompts appear only if mass flow is activated for both channels.
Table 5: Available Volumetric/Totalizer Units
English Metric
ACF = Actual Cubic Feet ACM = Actual Cubic Meters
KACF = Thousands of ACF KACM = Thousands of ACM
MMACF = Millions of ACF MMACM = Millions of ACM
SCF = Standard Cubic Feet SCM = Standard Cubic Meters
KSCF = Thousands of SCF KSCM = Thousands of SCM
MMSCF = Millions of SCF MMSCM = Millions of SCM