Panametrics DigitalFlow GS868, Programming Manual, Page: 47 / 146

DigitalFlow™ GS868 Programming Manual (2-Channel) 37
Chapter 2. Displaying Data
Chapter 2. Displaying Data
2.1 Introduction
This chapter explains how to display measurement data in various formats. Each of the two display screen panes
may be programmed independently.
Note:
The instructions in this chapter assume that the left display pane is active. If the right display pane is active,
simply change all
[F1]-[F4]
designations to
[F5]-[F8]
.
The following submenus are included in the
Display Menu:
• BIG - displays a single measurement in large size text
• DUAL - permits the simultaneous display of two measurements, in the same screen pane, in standard size text
• GRAPH - displays a graph of either velocity or volumetric flow versus time
• LOG - displays the data stored in a log file either graphically or numerically
• SIGNL - graphically displays any one of five transducer signals versus time
• BACKL - sets the time that the LCD display backlight remains on before it is automatically turned off.
• SLEEP - blanks out the display screen until a key is pressed.
Refer to Figure 15 on page 87 of Appendix A, Menu Maps, and proceed to the appropriate section to set up the Model
GS868 display screen(s), using one of the listed submenus.