Panametrics DigitalFlow GS868, Programming Manual, Page: 39 / 146

DigitalFlow™ GS868 Programming Manual (2-Channel) 29
Chapter 1. Programming Site Data
Setting up the RTD Inputs
Option cards with RTD inputs have a temperature range of –100° to 350°C. Complete the following steps to set up the
two RTD inputs of an option card installed in Slot x:
1. Press [F1] to set up RTD input A or [F2] to set up RTD input B.
Note:
The setup of RTD input A is used as an example. Identical procedures would be used to set up RTD input B.
2. Enter a label of up to eight characters and press [ENT] .
3. At the
Input Measurement prompt, press
[F1] = OFF to disable RTD input A and return to the previous prompt, or
press [F2] = TEMP to enable RTD input A.
4. Enter the
Zero Value for the low end of the chosen input range and press [ENT] .
5. Enter the
Full Scale Value for the high end of the chosen input range and press
[ENT] .
6. Press [F1] - [F2] to set up another input or press [EXIT] to select another slot for set up.
For instructions on setting up additional inputs and/or outputs, proceed to the appropriate section. Otherwise, press
[EXIT] twice to return to the Global PROGRAM prompt.
Procedure Options
After completing the above steps, the meter returns to the Global I/O prompt. Continue as follows:
• To continue programming the meter, refer to the menu maps in Appendix A and navigate to the desired menu.
Then, proceed to the appropriate section of this manual for instructions.
• To leave the
User Program and retain the previous settings, press
[EXIT] twice and then press [F1] = NO at the
SAVE prompt. Any programming changes will be discarded and you will be returned to the data display.
• To leave the
User Program and return to measurement mode, press [EXIT] twice and then press [F2] = YES at
the SAVE prompt. Your programming changes will be entered into the meter’s memory, and you will be
returned to the data display.