PaloAlto Networks M-200, Hardware Reference Manual, Page: 29 / 52

Install M-200 or M-600 Appliance in an Equipment Rack
Install the M-600 Appliance in a 19” Equipment Rack
The following procedure describes how to install the M-600 appliance in a four-post equipment
rack. The rack kit includes the hardware required to install the appliance in most equipment racks.
Extra screws and washers are included.
STEP 1 | Aach the inner-rails to each side of the appliance by aligning the square holes on each
rail with the rail hooks on the appliance and then sliding the rails toward the front of the
appliance to engage the hooks. Secure the back part of each rail to the appliance using one
M4 screw for each rail.
The inner-rails also use a pressure-lock clip (one on each rail) that locks the rails to the
appliance. Remove the M4 screw and pull the metal tab on the clip to remove the rail
from the appliance.
STEP 2 | Install one outer rack-mount rail to each side of the equipment rack. Push the two rail hooks
(on the front and back of each rail) in to the square rack holes and push down to engage the
hooks. The release buons located above each rail hook will depress as you push the rail
hooks in to the square holes. Secure the back of each rail to the rack using two M5 screws
M-200 and M-600 Appliance Hardware Reference 29
©
2021 Palo Alto Networks, Inc.