Palm Tungsten Tungsten C, Handbook

Page: 317 / 444

Customizing HotSync application settings
305
6.
If you are attached to a network, click the Network tab to display the network
settings and adjust the options as needed. For more information, see
“Conducting network HotSync operations” later in this chapter.
7.
Click OK.
To set the HotSync options on Mac computers:
1.
Double-click the HotSync Manager icon in the Palm folder.
2.
Click the HotSync Controls tab and select any of the following options.
3.
If you are using the USB cradle/cable, you do not need to adjust the settings on
the Connection Settings tab for a direct HotSync operation; they are set
automatically when you perform the first HotSync operation.
4.
Close the HotSync Software Setup window.
Customizing HotSync application settings
For each application, you can define a set of options that determine how records
are handled during synchronization. These options are called a
conduit . By default,
a HotSync operation synchronizes all files between the handheld and Palm
Desktop software.
In general, you should leave the settings to synchronize all files. The only reason
you might want to change these settings is to overwrite data on either your
HotSync
Enabled/
Disabled
Activates the HotSync software and prepares your computer
to synchronize with your handheld. By default, the transport
monitor is enabled whenever you start your computer.
Enable HotSync
software at
system startup
Activates the transport monitor automatically each time you
start your computer. If this option is not selected, you must
open HotSync Manager and select the Enabled option before
you can perform a HotSync operation.
Show more detail
in HotSync Log
Includes more troubleshooting information in the log that is
generated when you perform a HotSync operation.
Shown with
Mac OS X