Palm P10802U, Handbook

Page: 8 / 172

Page 8 Palm™ Portable Keyboard Handbook
To connect your handheld:
1. Line up your handheld with the angle of the support bracket.
2. Slide your handheld securely onto the keyboard docking
connector. Your handheld turns on automatically.
After you install the keyboard application and connect the handheld,
you can begin typing.
Note:
If you connect your handheld to the keyboard before installing
the keyboard PRC file, you will start a HotSync operation.
Install the keyboard PRC file first.
To remove your handheld:
■ For the Palm m500 series:
Tilt the handheld forward, and then pull
up.
■ For the Palm III series, Palm VII series, Palm m100 series, and Palm V
series:
Pull handheld up.
Closing the Keyboard
When you finish using your keyboard, remove the handheld, unlock
and fold up the keyboard, and close it back into a portable case.
To close the keyboard:
1. Pull your handheld up and away from the docking connector.
2. Fold the docking connector support bracket in and down flat; then
slide it back into the keyboard.
3. With your thumbs, slide the side-grips to the outside of the
keyboard. Make sure the two outer keyboard sections are as far
apart as possible.
Palm m500 series Palm V series Palm III series,
Palm VII series, and
Palm m100 series