Palfinger V 1000 LQ, Fitting Instructions Manual

Page: 9 / 34

5
Fitting
General
The instructions assume that the rear frame is constructed of steel.
If it is of aluminium or other, steel strips should be bolted to the rear frame so that the lift can
be welded to these.
If there is any doubt concerning the strength of the rear frame to support the lift, suitable
reinforcing must be fitted.
Where the lift is to be fitted to a dropside body specific fitting kits are available from Palfinger
Tail Lifts UK or where these are not available bracing for the top and bottom of the columns
will be required as well as a the construction of a suitable mounting frame.
Unpack Equipment
Unpack the lift and check for possible damage in transit.
Check that the kit contents are as stated on the packing list.
Work Light
A work light is available from PALFINGER Tail Lifts Ltd for installation if requested.
Checks before Fitting
All the requirements specified in the relevant chassis manufacturer's Body Builders
Handbook are complied with for this vehicle/tail lift combination.
The vehicle has a box body with a flat back. (Packing may be used to overcome minor
projections such as rivets or bolt heads.)
The rear closure is roller shutter or special door hinges. (Palfinger Tail Lift do not
recomented to use doors for the rear closure with this lift.)
The rear frame has adequate strength.
The rear frame is steel of adequate strength.
There are no projections from the vehicle rear below floor level.
Some projections are allowable, refer to Appendix 1.
Chassis is clear for mounting drop arms. (If fitted)
Does the spare wheel need re-sitting.
After fitting, vehicle rear lights will conform to Road Traffic Regulations.