ILK
22/33/44/55/66
I
NSTALLATION
M
ANUAL
Revision 1.6
- 17 -
Mount Fixture
Maintain Parallel with
Truck Body floor
Lift Arm
Mount Fixture as shown
90.00°
Figure 5.2: Mount frame alignment with fixture
6. With the mount tube held in place, position the mount plates over tube and against truck frame. Po-
sition them with angle facing to back of truck and clamp them to truck frame.
7. Refer to 5.3 for Bolt-On Mount Plates for model ILK22 only
Before any welding is started, check that liftgate is balanced and not binding in mounting
fixture, you should have equal pressure on each lift-arm pin. This is very important to make
platform align with truck sill.
Be certain to pull out power tray before welding. IMPORTANT!!!!!!
8. The reservoir is made of plastic and you will burn it while welding. To pull out tray, open curb side
mount tube rubber cover, simply remove the clamp and the tray holding bolt and detach the ground
strap and control power connector for the tray. Pull on tray until the hoses are stretched and the tank
is further out than the point of welding, open driver side to verify that hoses or cables are not touch-
ing inside of tube wall. Insulate the inside of the mount tube to protect the hoses from the heat dur-
ing welding
Reservoir
Mount Frame Door &
Control PCB
Pump
Bolt Tab
Mount Frame
Pull Out
Mount Plate
