33
Palax D270 Active
Translation
1-2017
8.
Maintenance of the machine
Note! Before performing any service measures, always stop the machine and disconnect it from
the power source.
If a service measure requires the power source to be running, particular caution must be
exercised!
After completing the service measures, and before starting the operation, fasten all the
protective covers in place, ensure that the protective devices are in order and test run the
machine in accordance with the instructions in point 3.3.
8.1.
Removing the covers
Loosen the attachment screws for the
covers, Fig 8.1 A, a few centimetres,
and let the screw fall in the direction of
the arrow to the lower edge of the
slot, Fig 8.2. After this, remove the
cover by pulling it. The attachment
screws need not be taken away for
removal of the protective covers.
8.2.
Crosscut saw-bar
Changing and tightening the saw-
chain
Open the protective net.
8.1
A
8.3
1
2
8.2
