Page 1 of 2
Rev. A
PahaQue Wilderness, Inc
T@B 400 Trailer Tent
SETUP INSTRUCTIONS
Thank you for purchasing the T@B 400 Trailer Tent, another quality product built in the USA by PahaQue Custom Shop. This product is
backed by our Limited Lifetime Warranty against any and all defects in materials and workmanship. When used and cared for properly, this
product will provide many years of reliable service.
A FEW QUICK NOTES:
SET-UP
---Your Tent can be easily set-up in 10 minutes or less by one or two people, if you follow the basic sequence detailed below. If
time allows, we would recommend that you read through these instructions in their entirety and do a practice set-up at home before
heading into the wilderness. Then you can be sure all components are present & functional, and proceed through the set-up sequence at a
leisurely pace to learn the most efficient techniques.
TAKE DOWN
--- For the take down, simply reverse the set-up sequence.
LONG TERM STORAGE
--- Your T@B 400 Trailer Tent is more likely to be damaged by mold, mildew or bacteria during storage
than by elements while set up and in use. Make sure that all food or other organic material is removed, and that your tent is thoroughly
dry before packing into the stuff bag. If you have to pack up and leave the campsite while your tent is damp, set it up later at home &
allow it to dry thoroughly for long-term storage.
How to install your
T@B 400 Trailer Tent
by PahaQue
USEFUL TIPS:
If you have difficulty sliding the keder cord through the rail, a little dish soap or dry silicon lubricant will help
without damaging the Tent.
Do not store your Tent while wet for any extended period; always dry tent completely, inside and out, prior to
long-term storage. Damage due to mold/mildew is not covered by warranty.
You can register your product online by visiting
www.pahaque.com
, or by calling us toll-free at
1.888.700.TENT
(8368).
Inventory
The following parts are included with your T@B 400 Trailer Tent:
Tent Body
Wheel Well Cover
Two Bottom Skirt Attachment Cords w/Velcro (45” rear, 90”front)
One Front Arch Pole (fiberglass)
Five Roof Poles (Aluminum)
Ground stakes – 10
1.
Position
Tent Body
in front of trailer roof-side-up with keder cord facing trailer.
Start by inserting forward end of the keder cord, that is, the end that will end up
toward the front of the trailer, into the rear end of the keder rail on the trailer. Photo A
