U5042A PAG PULSAR INSTRUCTION MANUAL
U5042A PAG PULSAR INSTRUCTION MANUAL
PAG Pulsar
All-Chemistry Charging System
Instruction Manual
CONTENTS
SECT ION
PAGE
1
SAFETY
2
2
SPECIFICATION
3
3
INSTALLATION
6
4
OPERATING INSTRUCTIONS
6
5
SERVICING & REPAIRS
1 2
6
WARRANTY
1 3
SAFETY
SECTION 1
1.1
This manual contains important safety and operating instructions.
Read these fully and note all warnings before using the charger.
Please follow all instructions and retain this manual for future reference.
1.2
PAG Pulsar chargers are not intended for any use other than the charging
of batteries as detailed in Section 2 - 'Specification’.
1.3
IMPORTANT: Use only on AC supplies 100-250V, 50/60Hz.
Supply connection to the unit should be made using only the standard
lead supplied with this equipment.
1.4
Protect the power cord from being walked on or pinched, particularly at
plugs. Unplug this apparatus during lightning storms or when unused for
long periods of time.
1.5
Ensure that the ventilation slots are not obstructed when in use, e.g. do
not site the charger on a deep pile carpet, or cover when in use.
1.6
WARNING: Indoor use only. To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture.
1.7
Although the charger is reverse polarity and short circuit protected,
extreme care should always be taken not to short circuit the battery
itself. Rechargeable batteries can deliver power at a very high rate, and
short circuiting even a partially charged battery could result in a fire or
personal injury. PAG supplies a range of connector leads for most charging
requirements, and does not accept responsibility for any other form of
charging connection.
1.8
Do not disassemble the charger. There are no user-serviceable parts
inside. Incorrect re-assembly may result in a safety hazard.
1.9
Double Insulation: When servicing use only identical replacement parts.
1.10 Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as supply cord or
plug is damaged, liquid has been spilled, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped. In
this event you should seek advice from your nearest PAG Dealer, or from
PAG USA by telephoning 818 760 8265, or direct from PAG Ltd., London,
by telep44 (0)20 8543 3131.
1
2