7
1. Carefully disconnect the four-wire power cable and the flat data interface cable
from the hard disk drive.
Fig. 7:
Disconnecting cables from the hard disk drive
2. Support the drive to ensure it does not fall.
3. Remove the screws securing the internal 3.5-inch hard disk drive to the chassis.
Fig. 8:
Removing the hard disk drive screws
4. Remove the drive out of the chassis.
Removing Add-In Cards
To remove add-in cards, first remove the front bezel (see section
) and remove the left side cover (see section
); then
follow the steps below:
1. Disconnect all cables from the add-in card to be removed.
2. Remove the screws securing the card in the slot.
3. Carefully take out the card from the slot.
Removing the Front USB Port
To remove the front USB port, first remove the front bezel (see section
) and remove the left side cover (see section
); then
follow the steps below:
1. Remove the screws holding the USB port to the chassis.
Packard Bell Daytona Disassembly Manual
