T
T
79
78
15
WARNINGS
1. For units for use in other than single-family dwellings, a clearly labeled emergency switch shall be provided as part of the
installation. The switch shall be readily accessible to the occupants and shall be installed at least 5 feet (1.52 metres) away,
adjacent to, and within sight of the unit.
2. Any damaged cable must be immediately replaced by qualified personnel.
3. Turn power off before servicing or modifying any cable connections in this unit.
4. To prevent electric shock hazard and/or water damage to this control, all unused bushing conduits must be plugged with the
attached nipple.
5. This controller must not be installed in proximity of highly flammable materials.
6. Low supply voltage or improper wiring may cause damage to this control system. Read and follow all wiring instructions when
connecting to power supply.
7. This pack contains no user serviceable parts. Contact an authorized service centre for service.
8. All connections must be made by a qualified electrician in accordance with the National Electrical Code and any state,
provincial or local electrical code in effect at the time of the installation.
9. Product must be disposed of separately in accordance with local waste disposal legislation.
10. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they are supervised and/or have been given instructions concerning use of the
appliance by a person responsible for their safety.
11. Children should be supervised to ensure that they do not play with the appliance.
12. Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
13.
caution
:
in order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied
through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the
utility.
14. Parts containing live parts, except parts supplied with safety extra-low voltage not exceeding 12 v, must be inaccessible to a
person in the spa.
15. Parts incorporating electrical components, except remote control devices, must be located or fixed so that they cannot fall into
the spa.
16. Parts are to be installed in the correct zone and equipotential bonding carried-out in accordance with the wiring rules.
17. Clearance and minimum distance between the various parts of the appliance and the surrounding structure are not specified
as long as they are sufficient so that the ambient temperature around the controller does not exceed 60°C (140°F).
save
these
instructions
before
installing
or
connecting
the
unit
,
please
read
the
following
.
Aeware®, Gecko®, and their respective logos are Registered Trademarks of Gecko Alliance Group.
in.ye™, in.yt™, in.keys™, in.touch™, in.k200™, in.k400™, in.k450™, in.k600™, K-19™, K-35™, K-8™, in.k1000™, in.k800™, in.k500™,
in.k300™, in.flo™, in.put™, in.seal™, in.link™, in.t.cip™, in.stik™, heat.wav™, Y Series™, and their respective logos are Trademarks of Gecko
Alliance Group.
All other product or company names that may be mentioned in this publication are tradenames, trademarks or registered trademarks of their
respective owners.
Troubleshooting guide
Y series and in.xe
Possible error codes
Error code explanation
Step by step troubleshooting
Troubleshooting Guide
T
T
