Pacific Power Source 105LMX, Operation Manual

Page: 212 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 212 of 463
Command Syntax MEASure:KWHour:RESET
Description This command resets all energy measurements to zero and resets the
time counter.
Parameters None
Parameter Format n/a
Example MEAS:KWH:RESET
Query Format MEASure:KWHour:ETIMe?
Description This command returns the accumulated energy measurement time in
seconds.
Returned Data Format <nr2>
Query Example MEAS:KWH:ETIM?
120.5
Command Syntax MEASure:KWHour[:STATe] <b>
Description This command enables or disables the KHh measerments. When
enabled, the energy time counter starts till reset with the
MEASure:KWHour:RESET command.
Parameters < 1 | ON | 0 | OFF >
Parameter Format <b>
Example MEAS:KWH ON
Query Format
MEASure:KWHour[:STATe]?
Description The query format of this command returns the setting of the KWh
measurement as either 1 (ON) or 0 (OFF).
Returned Data Format <nr1>
Query Example MEAS:KWH?
1
8.4.6 Other Measurement Commands
Query Format MEASure:TEMPerature:AMBient?
Description Returns the ambient temperature of the power source in degrees
celcius.
Returned Data Format <nr1>
Query Example MEAS:TEMP:AMB?
24