Pacific Floorcare RS28, Parts & Operating Manual, Page: 10 / 58

RETURN TO
TABLE OF
CONTENTS
- 7 -
CLEANING THE BATTERYSHIELD
®
SENSOR LIGHT PIPE
1. Locate and remove the battery cap with the BatteryShield
®
sensor module.
NOTE : Never remove the BatteryShield
®
sensor from the battery cap. Doing so will cause the BatteryShield® system to function
improperly.
NOTE : Take care not to damage the battery cap floats or the BatteryShield
®
sensor light pipe.
2. Thoroughly wipe the clear BatteryShield
®
light pipe with a clean rag, giving special attention to the tip.
3. With the battery cap still removed, cycle the key switch on to verify that the BatteryShield
®
LED remains on.
4. Turn off the key switch.
5. Carefully install the battery cap.
NOTE
: Whenever the battery cap is removed, ensure the Hydrolink
®
snake port is fully seated in the cap when maintenance is
complete.
6. Complete the Hydrolink
®
watering procedure described above.
7. Turn on the key switch and verify the light remains off.
8. The machine is ready for use.
CAUTION : Always wear protective clothing, gloves and goggles when handling and charging batteries.
NOTE : All repairs must be performed by a qualified service technician using approved replacement parts.