- 5 -
OPERATION
1. Follow all instructions from the chemical manufacturer
and fill the tank with a ready-to-use solution or mix to
the chemical manufacturer instructions.
Caution
: Do not spill the solution onto the air compressor.
Note
: Both discharge buttons should be completely open
while misting.
MACHINE USE
Note
: Both discharge valves should be completely open
while misting.
2. Plug the unit in to a 120 VAC GFCI protected power
outlet.
3. Turn the power switch ON to start the air compressor.
4. Set the pressure setting to 85 psi.
5. Verify that the air shut-off valve at the trigger gun is in
the closed position and open the air inlet valve on the
back plate.
6� Standard PSG-N130 Wand
: Point the discharge wand
in a safe direction and open the air shut-off valve at the
trigger gun. Then squeeze the trigger handle to begin
misting.
7� Extended MGA-RAC-N130 Wand:
Point the discharge
wand in a safe direction and press the red and blue
discharge trigger buttons at the same time to begin
misting.
8. To stop misting, release the red and blue discharge
trigger buttons.
