58
Axle Peg Assembly Instructions
Non-Threaded
First remove the axle nut from the wheel. There will be either
a retaining washer or a step retaining washer included. Place
this washer between the peg and the frame of the bicycle. Slide
the peg onto the axle, followed by a flat washer and lastly the
axle nut. Tighten the axle nut clockwise until the peg fits snugly
against the frame or fork. Repeat for all the remaining pegs.
Non-Threaded
Threaded
Threaded
This style of peg is threaded to fit the axle. Make sure the axle
nut is tight with a 15mm wrench. Place a screw driver through
the mounting holes of the peg and attach the peg to the axle by
turning clockwise. Tighten against the frame or fork for a snug fit.
Repeat for all the remaining pegs.
PLEASE NOTE: Not all axles are able to accept axle pegs.
Please consult the Pacific Cycle Service Department if you
have any questions. Some BMX bicycles come with two or
four pegs. If your bicycle is a Dirt Jumping style bicycle,
you will receive only two pegs. These are designed for the
front wheel. Freestyle bicycles come with four pegs, two for
each wheel.
