07
SINGLE OR MULTI
SYSTEMS
(Default setting is
Single)
You must set the system to
multi if more than one
systems are installed using
a single phone line. You
can connect up to eight
system on a single phone
line.
It is not necessary to set
the system to multi if sepa-
rate phone is used for
each system.
If system is set for multi,
Function Code 75 (Key
Press Beep) is disabled.
08
SYSTEM NUMBER
(Default Setting is
1)
It is not necessary to set
the system number if :
1. Remote touch-tone
programming is not
used.
2. Separate phone line is
used for each system.
10
CHANGE THE
WELCOME
SCREEN
Welcome screen is divided
into three segments. Each
segment consists of 16
characters. The welcome
screen can be a
combination of letter and
number.
Step 1
Log on to programming mode (see section 3.1),
the display shows:
Step 2
Enter Function Code 07 then press #, the
display shows:
Step 3
Enter
• 1 for Single system or
• 0 for multi systems
then press # or press
*
to keep the existing one.
Step 4
Proceed to step 2 and select the same Function
Code or different Function Code to continue
programming or press
*
to exit the programming
mode and you will hear
“Three Short Beeps”
.
Step 1
Log on to programming mode (see section 3.1),
the display shows:
Step 2
Enter Function Code 08 then press #, the
display shows:
Step 3
Enter the system number 1-8 then press # or
press
*
to keep the existing one.
Step 4
Proceed to step 2 and select the same Function
Code or different Function Code to continue
programming or press
*
to exit the programming
mode and you will hear
“Three Short Beeps”
.
Step 1
Log on to programming mode (see section 3.1),
the display shows:
Step 2
Enter Function Code 10 then press #, the
display shows:
Step 3
Press
*
to erase the
1st segment
then enter the
welcome message then press # # to proceed to
the 2nd segment, the display shows:
NOT AVAILABLE.
NOT AVAILABLE.
NOT AVAILABLE.
FUNCTION CODE
LOCAL PROGRAMMING
TOUCH TONE PROGRAMMING
Pach and Company
Chapter 3
Page 13
AeGIS 7000 Series
PROGRAMMING
Select Func:
_ _
SING=1, MULT=0: 1
Select Func:
_ _
SYSTEM #
[1-8] 1
Select Func:
_ _
Welcome to Pach’
1st segment
s Telephone Acce