WARNING: In order to avoid distraction, which could lead to an accident, the driver should never watch
the front or rear camera when the vehicle is in motion. Even when operated by the passenger, the
vehicle driver should maintain their attention on the road at all times.
DISCLAIMER: Under no circumstances shall the manufacture or the distributors of the BCI-FD21 be held
liable for claims of any loss or damage, consequential, direct or indirect, arising from the sale,
installation, or use of the BCI-FD21. The manufacture and its distributors will not, nor will they authorize
any representative or any other individual, to assume obligation or liability in relation to the BCI-FD21
other than its replacement.
AGREEMENT: End user agrees to use this product in compliance with the instructions and terms of use
above and with all State and Federal laws. PAC provides instructions and safety warnings with respect
to this product and disclaims all liability for any use not in conformity with those instructions or other
misuse of its product. If you do not agree, please discontinue use immediately and return product to
place of purchase. This product is intended for off-road use and passenger use only.
LED STATUS
Flashing Blue
Programming the video input
Cancelling the video input programming
There is no response to programming
Flashing Red
Flashing Purple
The video input was already programmed
Solid Purple
Interface is locked to another vehicle VIN
Solid Red
1. No video when I shift the vehicle in Reverse.
• Check that proper dip switches are selected and that power to the interface was disconnected and reconnected after these
settings are made.
2. Radio is displaying “CAMERA FAULT”.
• Camera inputs must be selected via dip switch setting for the interface to function properly. If not, the radio may display a blank
screen for as long as 15 seconds or display “CAMERA FAULT”.
• Be sure to set camera input dip switches according to your installation. For example, if you are using rear camera input,
camera configuration dip switch #1 should be on. If you are using the side camera inputs then camera configuration dip switch
#3 should be on. No other unused camera inputs should be on in the camera configuration dip switches.
• Check that the cameras are powered and are providing a video output.
3. The Side Cameras are not working while in drive and I activate the turn signal.
• Check the camera and vehicle configuration dip switches and consult the LED STATUS while activating the turn-signal.
4. Unable to program the proper video input selections.
• Check if the BCI-FD21 was programmed in another vehicle prior to this installation. Do this by following the instructions on pg3.
NOTE:
Previous vehicle is required for unlocking the module.
FAQs
Page 4
Rev. 071
9
16
PAC | Ph. 866-931-8021 | [email protected]
© 2016 AAMP Global
www.pac-audio.com
Camera Interface for Select Ford & Lincoln Vehicles with
MyFord Touch or MyLincoln Touch 8.4” Radios
BCI-FD21
