INSTRUCTIONS AND PARTS LIST EZ-STARTER AIRBRUSH 8/16/2019
EZ-STARTER
Single Action–External Mix–Siphon Feed
Instruction Manual & Replacment Parts
OPERATING INSTRUCTIONS:
Approximate Working Pressures:
• 20 lbs. or Less: Stipple and granulated effects, pressure will vary with viscosity of fluid.
•
20 to 30 lbs.: Medium consistency water colors, inks & dyes.
• 30 lbs. or
More: Heavy fluids, acrylics, reduced lacquers, varnishes, paints or ceramic glaze.
1.
Attach hose to air supply and allow air to blow a few seconds. Shut off before attaching to Airbrush. This procedure will
remove dirt from airline and hose.
Caution: Hold firmly and point away from face.
2.
Attach hose coupling to the airbrush.
3.
Attach Color Cup or Bottle to
#6
Needle by exerting a firm twisting motion to fit tapered tube securely into tapered Needle inlet.
4.
Fill Bottle 1/2 to 3/4 full. Use eyedropper or brush for adding small amounts of color to metal color cup. Vent hole must be kept
open.
5.
To Spray, hold Airbrush like a pencil comfortably between thumb and forefinger using middle finger as a guide and support.
Like writing, hold forefinger easily on Button and Press to open air valve.
6.
Regulate volume of color and size of spray by rotating
#5
Tip clockwise to increase and counter clockwise to decrease flow
of color.
CARE AND CLEANING:
1.
Pour any remaining color back into its original container.
2.
Wipe Bottle clean, using cloth moistened with proper solvent.
3.
Hold Airbrush at a downward angle and put a few drops of solvent through
#6
Needle, or fill bottle with Paint Cleaner to spray.
To flush out the remaining color in the H Color Adjusting Part Assembly, apply pressure to the
Button.
HOW TO OPEN CLOGGED FLUID PASSAGES:
1.
Agitate color in Bottle Assembly by placing finger momentarily over
#1
Aircap while air is passing through the Airbrush. This
will blow color back into bottle thus opening clogged fluid passages.
2.
Should Tip or Needle become clogged, pull
#8
Clip, unscrew Tip from Needle, gently pull back through support and remove
Tip.
3.
Clean Parts carefully, using nothing harder than a wooden toothpick & your paint cleaner.
4.
To reassemble, reverse this procedure.
5.
If the needle and tip are completely clogged, Remove
#7
“O”Ring (first) then soak in a closed bottle of proper solvent until
clean.
