P.Lindberg Talex EcoCut 135, Original Manual

Page: 145 / 148

33
MAN 9054233_9054739_9058170 EN V3
P. Lindberg A/S Sdr. Ringvej 1 www.p-lindberg.dk
Tel.: +45 7021 2626 DK-6600 Vejen E-mail: salg@p-lindberg.dk
Maintenance after use
Always clean the mower after use. Wash the lower components (holders, blades,
counter blades) with a pressure washer and place the mower on a flat hard surface.
Inspect all joints. Worn or damaged parts must be replaced with new ones. Check all
bolted joints and tighten loose bolts and nuts (see table below).
Resistance 6.8 8.8 10.9 12.9
Thread Torque (Nm)
M5 4.5 5.9 8.7 10
M6 7.6 10 15 18
M8 18 25 36 43
M10 37 49 72 84
M12 64 85 125 145
M14 100 135 200 235
M16 160 210 310 365
M18 220 300 430 500
M20 310 425 610 710
M22 425 580 820 960
M24 535 730 1050 1220
It is also necessary to check the drive belts’ tightness. If a belt is damaged, replace all
the belts with a set of new belts (always replace in sets). Adjust the whole set
according to the instructions in the previous section. Lubricate the mower as
instructed in the subsequent section. Keep all safety labels on the mower clean.
Lubrication:
All service and maintenance must be done with the engine switched off,
equalised pressure and stopped rotations, and both the tractor and
mower must be properly secured.
Avoid contact with pressurised oil!
Wear personal protective gear: protective clothing, safety shoes, glasses
and goggles.
Use and lubricate the telescopic PTO shaft as specified in the instructions.