27
MAN 9054233_9054739_9058170 EN V3
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 7021 2626
DK-6600 Vejen
E-mail: [email protected]
6.
Insert the safety catch into the extension on the linkage and secure it with a pin.
Adjusting the rotary mower:
When the mower is set in the mowing position, the discs must be parallel with the
ground. In this position the clevis bolt (1) must be in the centre of the slot on the
support bar (2).
Changing the mowing height (H):
1.
Set the rotary mower in the transport position and lift it to its highest position, stop the
tractor and switch off its engine.
2.
Support one of the discs to prevent the mower from falling.
3.
Unscrew the bolts (1) and remove the slide disc (5).
4.
Unscrew the bolts (3) holding the resistor disc (2) and remove the disc.
5.
Adjust the cutting height on the spacer rings (4).
6.
Assemble the parts in reverse order.
Repeat the above workflow on the other disc.
Summary of Contents for Talex EcoCut 135
Page 2: ......
