11
MAN 9039267 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
Replacing the slats
1.
Ensure that power is disconnected.
2.
Remove the side panels.
3.
Move the R-type button and remove the connection clip.
4.
Pull out the plastic handle and press the handle to the front position.
5.
Replace the slat with a new one and secure the handle, etc.
6.
Re-fit the side panels.
Troubleshooting
Problem
Cause
Solution
Fan does not start.
No power.
There is a fault with the
power connection.
The fuse has blown.
Check and remedy.
Check and remedy.
Check and replace if
necessary.
The fan rotates but
without effect.
Incorrect direction of
rotation.
Loose V-belt.
Dirty safety guard.
Change direction of rotation.
Tighten the V-belt.
Clean.
The fan’s slats cannot
completely open.
Dirty.
Fitted incorrectly.
Clean.
Adjust, cf. the manual’s
instructions.
