6
DISASSEMBLY INSTRUCTION
WARNING
At no stage is it necessary to apply any
excessive force to achieve any of the
above steps. The frame is sprung loaded
and if the correct action is applied the
tent will pack up with little or no force
required. Excessive force will result in
damage to the frame and this is not
covered by warranty.
IMPORTANT
Do not store your tent when damp or
dirty. If you have no option but to pack
away a damp or dirty tent, as soon as
possible lay it out to air in a cool, dry and
shaded area to dry and clean. Only pack
it away for storage when completely dry.
STEP 1:
STEP 2:
Remove pegs with a claw hammer or peg
puller. Do not remove pegs from the
ground by pulling on tent base as this
may cause damage to the tent.
Position yourself along the side of the
tent, see Diagram 1.
STEP 3:
STEP 4:
With your right hand collect and hold the
centre of the two roof pole loops, see
Diagram 2.
While holding the two roof poles with
your right hand collect and hold the
centre of the two floor pole loops in your
hands, see diagram 3.
STEP 5:
STEP 6:
Holding all poles loops together in your
left hand, now bring your left hand down
towards your left knee, the tent will
change from horizontal to vertical as you
do this step, see Diagram 4.
Place your right hand on top of where the
roof and floor poles are joined, see
Diagram 4.
STEP 7:
Holding the junction of the roof and floor
pole loops, bring your right hand down
towards your ankles, see Diagram 5.
STEP 8:
As you finalise step 8 carefully release two
of the four pole loops in your left hand so
the released two pole loops go under the
two pole loops still in your left hand, see
Diagram 6.
STEP 9:
Neatly pack down all pole loops, see
Diagram 7.
STEP 10:
Once all pole loops are packed flat, slip
the attached elastic strap over the pole
loops to hold in place, see Diagram 8.
STEP 11:
Place tent in carry bag.
