2. CHUCK
3. CONTROLS
Fitting Accessories
Speed Selection Dial
Mode Selector
Forward/Reverse Lever
The speed selection dial restricts the amount the on/off trigger can be
pressed, allowing you to set a desired maximum speed.
The drill features a hammer function for drilling into masonry products.
1 For a faster
speed, rotate the
speed selection
dial clockwise.
2 For slower
speeds, rotate the
dial anti-clockwise.
1 To set the drill into
hammer mode slide the
selector left, towards the
hammer icon.
2 For drilling mode slide
the selector to the right,
towards the drill icon.
1 To set the drill to forward
rotation, push the lever to
the left side of the drill.
2 For reverse rotation, push
the lever to the right of the
drill.
Drill
Hammer
REV
FWD
1 Open the chuck jaws by
rotating the chuck anti-
clockwise.
3 Hand tighten the chuck.
2 Insert the drill bit
making sure it
is centred in the
jaws.
4 To secure the bit
in the jaws, insert
the chuck key into
1 of the holes on
the chuck and
rotate clockwise
until tight.
Repeat for
remaining 2 holes
