1.
Thread an Ejector Tube (D) into each end of the Slotted Ejector Tube (C). Make sure the arrows
embossed on the ends line up with each other.
2.
The Slotted Ejector Tube (C) has letters embossed on each end (A & B). Insert the ejector tubes
into the T-shaped Handle (A) with the letter B in first. Make sure the slot on Slotted Ejector Tube
(C) is facing in the same directions as the screw holes on the end of the T-shaped Handle tube.
3.
Slide the Spring (E) over the top part of the ejector tube (T-Shaped Handle end).
4.
Slide the Rounded Cap (F) over the top part of the ejector tube. Secure the round cap by
threading a ¾”L Screw (K) through the centre of the rounded cap into the ejector tube.
5.
Slide the Plastic Sleeve (H) over the ejector tube (opposite end of the round cap) onto the T-
shaped Handle. Make sure the end with the wider slots (inside of sleeve) is inserted first.
6.
Slide the 3 Prong Tube (B) over the ejector tube and connection point of the T-shaped Handle.
Make sure the slots (opposite end of prongs) on the 3 prong tube line up with the compressed
tubing sides on the connection point of the T-shaped handle. You may need to push firmly to
assure all four holes line up (2 in front and 2 in back).
7.
Place the Ejector Cap (G) with the flat surface facing outward over the ejector tube (in between
the prongs) and secure it by threading in a ¾”L Screw (K) through the ejector cap into the ejector
tube.
8.
Slide the Plastic Sleeve over the connection point of the t-shaped handle and the 3 prong tube.
Make sure the holes line up on both sides.
9.
Insert the Hex Nut (J) into the Plastic Sleeve (into hexagon shaped opening). Hold the hex nut
with one hand as you thread the 1”L Screw (I) (through the Plastic Sleeve, T-shaped handle, and
3 prong tube) into the hex nut from the opposite end.
USER MANUAL Model No: 3804