RT1003 Manual
Revision:
190628
63
The pulses per metre should also be specified. A value that is accurate to 10% is sufficient
unless the figure is known more accurately. The RT1003 will improve this scaling factor itself
when GNSS is available.
Local co-ordinates
The RT1003 can output the displacement from an origin in a local co-ordinate grid. To use
this option, a new origin must be defined; the latitude, longitude and altitude for the origin
must be entered along with an angular offset for the X-axis. Local co-ordinates are fully
explained on page 24.
Serial 1 output
Figure 36.
NAVconfig serial output properties
The NMEA tab is enabled when Packet is set to NMEA.
The serial port can be configured to output different types of message (see Table 18). To
enabled serial output, click in the Setting column, then click the
button to open the
properties window, shown in Figure 36.
Select a
Packet
type and
Baud rate
. By default, data on the serial port is output using 8-N-1,
although odd/even parity and two stop bits are available by using Advanced commands.
Please contact [email protected] for details on this.