Cypher SPM
User Guide
5. Separate the backpack from the chassis.
l
Slowly pull the backpack toward yourself.
l
Guide both the disconnected pass-through board
and the ground cable through the hole.
l
Remove the pass-through board from the backpack
by pulling it out toward yourself. Set this board aside
(it ships in the View Module optics box, see
module removal and packaging on page 237
).
6. Carefully take the backpack off the hinges.
l
Pull up on the backpack.
l
Place on a safe surface.
Do not place the backpack on its tall side. If it falls
over you can cause severe damage!
7. Replace the foam removed in step 2.
8. Tape the ground cable to the backpack itself.
Kapton tape is preferred.
9. Place the backpack in an anti-static bag and tape shut.
10. Put the backpack in the backpack box and tape shut.
31.8 Chassis removal and packaging
Call or otherwise contact Asylum Research and talk to us before moving anything. Chances are
that with a few phone calls and the help of this chapter you can do the job yourself. Not calling us
will likely result in instrument damage, costly repairs and downtime, and the voiding of your war-
ranty.
Page 227 of 243
31 Shipping or moving
