Cypher SPM
User Guide
12. Pack the scanner in the shipping box.
l
Place the scanner carefully on the bottom foam.
l
Be careful putting on the top foam; make sure it is
the right side and lines up with scanner already in
box.
l
Close and tape shut the box.
The scanner box should remain upright at all times
when shipping on crate or pallet.
31.6 Removing the enclosure top cover
The enclosure top is the only thing preventing your Cypher SPM from sliding around inside its
enclosure. Be especially careful while removing and replacing the cover and in general any time the
cover is missing. The Cypher SPM is heavy, but it can slide around. If it does slide around, the elec-
trical connections can be dislodged or even damaged.
Tools
Part# 290.134: 3/32” Hex driver
Minimum preparation
System shutdown (see
Complete system shutdown on page 218
).
1. If in place, remove the airflow shield above the scanner and set aside.
It is magnetic and should pull off easily.
2. Remove the optics cover in front of chassis and view module and set aside.
It is magnetic and should pull off easily.
31 Shipping or moving
Page 222 of 243
