Version 1.4 rev 23 Oct 2017
Aspen
42
9.5.2 m
ounTing
The
f
ilTer
w
heel
To
The
c
amera
1. Mount the adapter flange to the front of your camera using M4 7 x 10mm flathead screws. Make sure counter
sunk features are facing up so screws mount flush with adapter surface. There are two hole patterns machined
into the flange to accommodate different camera sizes.
Note: the following images show the Filter wheel installation for the Alta model. The steps are identical for the
Aspen series.
2. Line up the Filter Wheel with the adapter flange in the configuration shown below so the two mounting holes
line up with the threaded holes of the flange.
3. Lightly screw in two #10-32 x 7/16 buttonhead screws and flip the assembly upside down to mount the other
two buttonhead screws in the rear of the plate. Fasten all four screws using the Allen wrench.
