OXE OXE-200 HP, User Manual

Page: 43 / 72

37
Check power trim and tilt system
!
WARNING
Never get under the lower unit while it is
tilted. Risk for severe injury if the outboard
accidentaly falls!
Make sure no person is under the outboard
before performing this test. Risk of body
parts to be crushed between outboard
and clamp bracket when the outboard is
trimmed or tilted.
1.
Check the power trim and tilt unit for any
signs of oil leaks.
2.
Operate each of the power trim and tilt
switches on the remote control and lower
cowling to check that all switches work.
NOTE!
The ignition key must be in
IGN&ACC
position.
3.
Tilt up the outboard and check that
the tilt rod and trim rods are extended
completely.
Tilt and trim rods, manual valve
4.
Check that the tilt rod and trim rods are
free from corrosion or other flaws.
5.
Activate the tilt-down switch until the
rods have retracted completely into the
cylinders.
!
CAUTION!
The outboard can belowered by carefully
turning manual valve, should the electric
system fail.
Ensure that the manual valve is tightened
before starting the outboard.
Tilt and trim switch on cowling
6.
Activate the trim-up switch until the tilt
rod is fully extended.
7.
Tilt the outboard down. Check that the tilt
rod and trim rods operate smoothly.
NOTE!
Consult your dealer if any operation is
abnormal.
Te
ch
ni
ca
l d
at
a
M
ai
nt
ena
nc
e
O
per
at
in
g
O
ve
rv
ie
w