OXE OXE-150 HP, Installation Manual

Page: 68 / 68

68
OXE 150/200 HP INSTALLATION MANUAL
ELECTRIC POWER CABLE CONNECTION PROCESS
1.
Install a main electric power switch on the (B+) side ( See specifications of length between battery and
switch )
From the main electric power switch:
2.
Install a separate (B+) power supply cable to the starter motor
(See layout and specifications of the cables in the picture below).
3.
Install a separate (B+) to the fuse box.
(See layout and specifications of the cables in the picture below) .
4.
Prior to installing the ground cable – ensure that the main electric power switch is disengaged (OFF and
ignition key is in the OFF-position.
5.
Install the ground cable to the specified torque on the alternator bracket and then install the other end
to the battery (B-) Ground. Connect a common ground cable (wire size same as engine battery cables)
between negative (–) terminals on starting batteries.
Cimco Marine AB , Metallgatan 19 A Ängelholm, SE-262 72 Ängelholm, SWEDEN
+46 (0)431-37 11 30, www.oxe-diesel.com
Printed in Sweden 2016. Copyright © 2016 Cimco Marine AB.