OXE OXE-150 HP, Installation Manual

Page: 39 / 68

39
OXE 150/200 HP INSTALLATION MANUAL
REFERENCES FOR CABLE HARNESS CONNECTIONS
G4-Tripple and G4-Quad applications in combination with 3.5” /7” Display
1.
Use a 100 A fuse on the Control Supply Cable.
!
WARNING!
No fuse on the Common supply cable, due to too high starter motor
current.
2.
Use two separate single channel switches or one dual-channel switch.
3.
The 3.5” Display is standard eqipment (one display per engine).
4.
The 7” Display is optional and replaces the 3,5” Display(s).
5.
Open loop at delivery.
The kill cord loop must be closed to enable fuel injection.
Open loop = fuel injection disabled.
Closed loop = fuel injection enabled.
6.
Use this NMEA2000 connector to connect your external equipment such as
GPS, VHF, Plotter etc.
7.
!
CAUTION!
If used, the User ignition signal should never power user applications
directly, but always control a relay that powers the user application, such
as
User NMEA
, lights, etc.
To enable the User ignition signal a 1A fuse must be installed in the
User ignition signal fuse 1A socket .
NOTE! Only by Cimco Marine approved components are allowed in the internal
NMEA-bus.