DRAFT 5
18
OXE 200 HP 3.5” DISPLAY MANUAL
TROUBLE SHOOTING
If a 3.5” display will not boot, ensure that the power is OFF.
Insert the USB Stick into the USB Port. Turn on the power while simultaneously
holding down
Key 1
and
Key 5
. The screen will turn BLUE and after a few seconds
the update process will begin. There will be on-screen information during the
update process. Please remove the USB Stick when prompted and the target unit
will automatically reboot into the new software.
NOTE!
If the screen turns RED at any point during the update process, after the
BLUE screen has been shown, there were problems reading the information
on the USB Memory Stick. This indicates that the software update has not been
applied.
NOTE!
Some USB Memory Sticks are not compatible with the target unit. If the
update does not install properly, please try a USB Memory Stick from a different
manufacturer.
After testing all available USB Memory Stick models from SanDisk we found them
all working without issues.
UPDATING THE 3.5” DISPLAY
Summary of Contents for 3,5" Display
Page 2: ......
Page 4: ...D R A F T 5 4 OXE 200 HP 3 5 DISPLAY MANUAL ...
Page 19: ...D R A F T 5 19 OXE 200 HP 3 5 DISPLAY MANUAL ...
