17
The gear should be shifted a
minimum of ten (10) times during
the first five (5) hours
5-10hrs
: Use varied load and rpm
but do not load the engine above
60% throttle and keep maximum
rpm below 2850. Do not stay at one
load and rpm configuration for more
than 30 minutes at a time.
The gear should be shifted a
minimum of ten (10) times during
the additional five (5) hours.
10-30hrs
: Use varied load and rpm
but do not load the engine above
80% throttle and keep maximum
rpm below 3000. Do not stay at one
load and rpm configuration for more
than 30 minutes at a time.
The gear should be shifted a
minimum of twenty (20) times
during the additional twenty (20)
hours
30-50hrs
: Use varied load and rpm,
the engine can be used up to 100%
throttle and full rpm. Do not stay at
one load and rpm configuration for
more than 30 minutes at a time.
The gear should be shifted a
minimum of twenty (20) times
during the additional twenty (20)
hours
Do an oil and filter change according
to
Maintenance schedule, 1st
inspection, after 50 h
.
Use oil and filter as specified in the
Engine Technical Manual.
NOTE!
When the initial oil change
is done, small metal particles may
be found in the break-in oil. Do not
be alarmed. This is typical during
break-in and will decrease as you
run the outboard.
Te
ch
ni
ca
l d
at
a
M
ai
nt
ena
nc
e
O
per
at
in
g
O
ve
rv
ie
w
