OWT Industries Black Max BM10700 Manual Download Page 1

BM10700/BM10711

This sheet updates battery installation and removal 
instructions on page 7.

R

  

7

0 0 0 0

0

OFF

ON

START 

ENGINE S

W.

CIRCUIT P

ROTECTO

R

ON

OFF

120V A

C/CA

120V A

C/CA

120V/240 A

C/CA

NEUTRAL F

LOATING

NEUTRAL F

LOTAS

Cord

Retainer

Cord

Retainer

major generator features

control panel

a. 120 V, 20 ampere Duplex receptacle 

20 amps of current may be drawn from each half of the recep-

tacle. However, total power drawn must be kept within nameplate rat-

ings. These receptacles may be used along with the twistlock recep-

tacle provided the generator is not overloaded.

B. 120/240 V, 30 ampere twistlock receptacle 

A  maximum  of  30  amps  may  be  drawn  from  the  120/240  volt 

receptacle, provided it is the only receptacle used. However, current 

must be limited to the nameplate rating.  If the 120/240 volt receptacle 

is used along with the 120 volt receptacle, the total load drawn must 

not exceed the nameplate ratings. 

c. circuit Breakers 

The receptacles are protected by an AC circuit breaker.  If the  

generator is overloaded or an external short circuit occurs, the circuit 

breaker will trip.  If this occurs, disconnect all electrical loads and try 

to determine the cause of the problem before attempting to use the 

generator again. If overloading causes the circuit breaker to trip, re-

duce the load. 

NOTE:  Continuous tripping of the circuit breaker 

may cause damage to generator or equipment. 

The circuit breaker 

may be reset by pushing the button of the breaker. 

D. engine on/off switch 
e. cord retainer

The cord retainer is used to prevent plugs from being pulled out 

of the 120-volt receptacles.

f. analog Hour meter
g. low oil shut Down circuit protector

 

Honda GX390 engine 

 

Electric Start

 

Cast-iron cylinder sleeve 

 

Low lubricant alert system

 

Receptacles on control panel 

 

Cord Retainers 

 

Automatic voltage regulator (AVR) 

 

8 gallon metal fuel tank 

 

Analog Hour Meter

 

Portability Kit  

This generator model is provided with both electric start and re-

coil start capabilities. Avoid prolonged cranking, as it can damage the 

engine. 

The battery provided is a nominal 12 volt sealed rechargeable 

lead-acid battery and can be operated in any position without leak-

age. It complies with non-spillable battery regulations. Its convenient 

size offers a 30% reduction over conventional batteries.
Length = 7.14 inches, Width = 3.03 inches,

Height = 6.59 inches, Weight = 12.56 lbs

18AH Rating

UL Recognized

Battery Kit Parts List

Item  Description 

Qty

A  

*Bolt, M5 x M12 ............... 2

B.   *Nut, 5 mm ....................... 2

C.   *Flat Washer, M5 ............. 2 
* These are standard parts available at your local hardware store.

Note: Brand New Generators are shipped with the Battery Con-

nections  disconnected.  The  Positive  and  Negative  Terminals 

must be connected to the Battery before the Electric Start Fea-

ture will work.

 

Initial Battery Connection - Refer to Installation Instructions Below.

Battery Installation & Removal:

Installation:

 Hook up the new battery, or re-install the new bat-

tery, as follows: Remove the nuts and bolts from the battery bracket; 

remove bracket and set aside.

 

Connect the red wire to the positive (+) 

terminal and the black wire to the negative (-) terminal with the bolt, 

nut, and washer provided. Make sure all connections are tight. Place 

the  battery  in  the  position  provided.  Replace  the  battery  bracket. 

 Install bolts and nuts; tighten securely.

 

Your battery is now connected 

and ready for use. 

Removal:

 Remove the nuts and bolts from the battery bracket; 

remove bracket and set aside. Remove the nut and bolt from the neg-

ative and positive post, being careful not to short across the terminals. 

(Shorting  the  terminals  together  can  cause  sparks,  damage  to  the 

battery or generator or even burns or explosions.) Always abide by 

the  safety  warnings  provided  with  the  battery.  Remove  the  battery 

and dispose of according to local and state regulations.

WarnIng:

To  reduce  the  risk  of  electrocution  or  explosion,  do  not  short 

circuit the battery terminals or charge in a sealed container. Keep 

sparks and flame away.

electrIc start

g

e

0 0 0 0 0

OFF

ON

START 

ENGINE SW.

CIRCUIT PROTECTOR

ON

OFF

120V AC/CA

120V AC/CA

120V/240 AC/CA

NEUTRAL FLOATING

NEUTRAL FLOTAS

Cord

Retainer

Cord

Retainer

B

D

f

a

c

NEGATIVE ( – )

TERMINAL

BLACK WIRE ( – )

POSITIVE ( + )

TERMINAL

RED WIRE ( + )

BATTERy 

BRACKET

BOLT

NuT

OWT Industries, Inc.

P.O. Box 35, Hwy. 8, Pickens, SC 29671, USA

1-800-726-5760

987000-597

2-2-09 (REV:01)

Reviews: