5.Panel Operation
11
Press a number key on the
numeric keypad
directly, the screen will pop out the
data input box, input the desired value. Press the
X
key on the
numeric
keypad
to delete the last digit, press the
←
Back
key to cancel the input, and
press the
Enter
key to confirm the input in default unit. Press the
MHz
,
kHz
,
Hz
,
mHz
,
uHz
softkeys to select the unit of the parameter. Press the
Cancel
softkey to
cancel the current input parameter value.
Figure 5-2: Use the numeric keypad to set the frequency
Set the amplitude
Press the
Amplitude/High
softkey to confirm whether the
Amplitude
menu item is
highlighted; if not, press the
Amplitude/High
sofkey to switch to
Amplitude
. In
Parameter 2
of Figure 5-1, a blinking cursor appears in the parameter value of
amplitude. Turn the
knob
to change the value directly, or use the
numeric keypad
to
input the desired value and choose the unit.
Set the offset
Press the
Offset/Low
softkey to confirm whether the
Offset
menu item is highlighted;
if not, press the
Offset/Low
softkey to switch to
Offset
. In
Parameter 3
of Figure 5-1,
a blinking cursor appears in the parameter value of offset. Turn the
knob
to change
the value directly, or use the
numeric keypad
to input the desired value and choose
the unit.
Set the high level
Press the
Amplitude/High
softkey to confirm whether the
High
menu item is
highlighted; if not, press the
Amplitude/High
softkey to switch to
High
. In
Parameter
