6.
Quick
Start
9
6.
Quick Start
Channel Output On/Off
Press
Output
to turn on/off signal output. The button is lit when it is in the On state. You
can configure the signal with the outputs off to minimize the chance of sending a
problematic signal.
To set signals
The waveform generator is available to set and output Sine, Square, Ramp, Pulse, Noise
and Arbitrary signals. Press
Waveform selection buttons
on the front panel: Sine
,
Square
, Ramp
, Pulse
, Noise
, Arbitrary
to enter waveform
setting interface. Different waveform has different parameters.
E.g.
: Press
button. Press
F1
button, the chosen menu item is highlighted, the
focused parameter is displayed in
Parameter 1
. Press
F1
button to switch between
Frequency/Period.
Two methods to change the chosen parameter:
Turn the
knob
to change the value of cursor position. Press
/
direction key to
move the cursor.
Press a number key in the front panel, an input box will pop up; keep going to input
the value. Press
direction key to delete the last number. Press
F1
-
F3
to choose the unit, or press
F4
to go to next page and choose other units. Press
F5
to cancel the input.
Figure 6-1: Set the frequency using number keys
Parameters of waveforms
Waveforms Menu Items