7.Demonstration
64
7.
Demonstration
Example 1: Measurement a Simple Signal
The purpose of this example is to display an unknown signal in the circuit, and
measure the frequency and peak-to-peak voltage of the signal.
1. Carry out the following operation steps for the rapid display of this signal:
(1)
Set the probe menu attenuation coefficient as
10X
and that of the switch in the
probe switch as
10X
(see "
How to Set the Probe Attenuation Coefficient
(2)
Connect the probe of
Channel 1
to the measured point of the circuit.
(3)
Press the
Autoset
button.
The oscilloscope will implement the
Autoset
to make the waveform optimized, based
on which, you can further regulate the vertical and horizontal divisions till the
waveform meets your requirement.
2. Perform Automatic Measurement
The oscilloscope can measure most of the displayed signals automatically. To
measure the period and frequency of the Channel 1 and the mean and peak-to-peak
voltage of the Channel 2, follow below steps:
(1)
Press the
Measure
button.
(2)
Select
Add
in the bottom menu.
(3)
Select
Source
in the right menu; select
①
in the left menu.
(4)
Select
Type
in the right menu; select
Period
in the left menu.
(5)
Select
Add
in the right menu, the period options added completes.
(6)
Select
Freq
in the left menu.
(7)
Select
Add
in the right menu, the frequency added completes, finish setting of
CH1.
(8)
Select
Source
in the right menu; select
②
in the left menu.
(9)
Select
Type
in the right menu; select
Mean
in the left menu.
(10)
Select
Add
in the right menu, the Mean added completes.
(11)
Select
PK-PK
in the left menu.
(12)
Select
Add
in the right menu, the PK-PK added completes, finish setting of CH2.
The measured value will be displayed at the bottom left of the screen automatically (see
).
Summary of Contents for tds series
Page 1: ......
