25
5.3 User setting list
Scope
Name
Description
Default
Communication
Baud Rate
Baud rate setting
9600 bps
CRC Alignment
Sending mode of CRC 16-bit check data Little Endian
Modbus Address
Modbus protocol address
0x01
Function
Startup Mode
The device is in local/remote control
mode after power on
Local
Rise Time Of Voltage
Rise Time Of Voltage Setting
30 mS
Fall Time Of Voltage
Fall Time Of Voltage Setting
0 mS
Rise Time Of Current
Rise Time Of Current Setting
30 mS
Fall Time Of Current
Fall Time Of Current Setting
0 mS
Auto-Reco(Fault)
After the fault occurs, disable the output
and check whether the output will be
automatically restored after the specified
time
30 S, Close
Auto-output(Hold)
After power-on, whether to automatically
start output after the specified time
30 S, Close
Timing output
Reference time: Use the clock or
power-on time as the reference time
Time range Enable: Enables or disables
this time range
On/Off time: set the time range
Disable
Parallel/Series
Connection
Type
of
connection:
independent,
parallel or series
Master/slave: the master or slave
Independent
Dry Contact output
Control mode: Disable, local or remote
control
Relationship: logic related to fault,
startup, condition setting, or time setting
Signal delay: delay from the dry contact
action after the logic is triggered
Disable
Dry Contact Input
Relationship: Disabled; Fault; Start or
buzzer
Disable
Protection
Over-Volt Value
Over-Voltage Protection Value
105% V
Rated
Time of Duration
Trigger over-voltage protection time
1000 mS
Over-Curr Value
Over-Current Protection Value
105% I
Rated
Time of Duration
Trigger over-current protection time
500 mS
Level1 Overload Value
Level1 overload protection value
105% P
Rated
Time of Duration
Trigger Level1 overload protection time
10000 mS
Level2 Overload Value
Level2 overload protection value
110% P
Rated
