5.Use the Arbitrary Function Generator (Optional)
100
⚫
To Turn On/Off Output of Channels
Push
or
to turn on/off output of the corresponding channel. The indicator
will be lighted when the corresponding channel is tuned on.
⚫
Channel Copy menu
Push
button to switch to
Channel Copy
menu.
Copy Channel
Select
CH2 To CH1
in the bottom menu to copy parameters of CH2 to CH1.
Select
CH1 To CH2
in the bottom menu to copy parameters of CH1 to CH2.
Frequency Lock
Select
Freq Lock
in the bottom menu as
On
, the frequency of the two channels can be
adjusted synchronously.
Amplitude Lock
Select
Ampl Lock
in the bottom menu as
On
, the amplitude of the two channels can be
adjusted synchronously.
Align Phase
Select
Align Phase
in the bottom menu to align the initial phase of two channel signals.
To Set Signals
(1)
Push
(single-channel) or
(dual-channel) button to show the bottom
menu of generator.
(2)
Select the desired waveform in the bottom menu, the corresponding menu is displayed
on the right.
(3)
The parameters can be set in the right menu.
To Output Sine Signals
The parameters of Sine waveform in the right menu are: Frequency/Period, Start Phase,
Amplitude/High Level, Offset/Low Level.
To Set the Frequency
Select
Frequency
in the right menu (if
Frequency
is not displayed, select
Period
and
push it again to switch to
Frequency
). Set the parameter in the right menu, see below.
Three methods to change the chosen parameter:
Summary of Contents for Dual-Channel Series
Page 1: ...XDS3000 Dual Channel Series Digital Storage Oscilloscopes User Manual www owon com ...
Page 29: ...3 Junior User Guidebook 22 Double Zoom Single Zoom ...
Page 42: ...4 Advanced User Guidebook 35 Figure 4 2 Rectangle window Figure 4 3 Blackman window ...
Page 43: ...4 Advanced User Guidebook 36 Figure 4 4 Hanning window Figure 4 5 Kaiser window ...
