5.Front Panel Operation
12
To set signals
The following describes how to set and output Sine, Square, Ramp, Pulse, Noise, Arbitrary,
DC signals and copy channel.
To Output Sine Signals
Press
button to call the user interface of Sine signal, the Sine waveform
parameters can be set by operating the Sine setting menu on the right.
The parameters of Sine waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level. You can operate the menu by using the menu selection buttons on the
right.
Channel
Setting menu
of Sine signal
Amplitude
Load
Offset
Current signal
Frequency
Parameter 3
Parameter 2
Parameter 1
Sine
Figure 5-2: The User Interface of Sine Signal
To Set the Frequency/Period
Press
F1
button, the chosen menu item is highlighted, the focused parameter is
displayed in
Parameter 1
. Press
F1
button to switch between Frequency/Period.
Two methods to change the chosen parameter:
Turn the
knob
to change the value of cursor position. Press
/
direction key to
move the cursor.
Press a number key in the front panel, an input box will pop up; keep going to input
the value. Press
direction key to delete the last number. Press
F1
-
F3
to
choose the unit, or press
F4
to go to next page and choose other units. Press
F5
to cancel the input.