How to reset to factory default through console interface?
WIAS-1200G provides function to reset password or default setting via “
Console Port
”, the following steps to
guide you the process.
WIAS-1200G console port is 9-pin serial port, and there is a console cable including in the packing.
Before to run
Windows Hyper terminal
program, you should connect WIAS-1200G and your PC with
cable.
Just plug the console cable to WIAS-1200G and your PC serial port, then to follow the steps to configure
Hyper Terminal and enter WIAS-1200G to access the command via console port.
Via this port to enter the console interface for the administrator to handle the problems and situations
occurred during operation.
i.
Use the console cable (included in your original package) to connect the Gateway to the PC (at the right COM
port); you will need console cable and a desk top with “
COM
” port to get started.
ii.
Please make sure the
COM
port is configured to map to the right physical connector that will be used
through Windows
Device Manager
>
Ports
and select
Prolific USB-to-Serial Comm Port
, in this
example, it is COM5.
