Overland Storage PowerLoaders AIT-2, User & Installation Manual

Page: 60 / 106

3-8
u
Operation
U
SING
P
OWER
L
OADER
™ M
ENUS
Using PowerLoader™ Menus
Use the PowerLoader™ menus (shown in the following illustration) to display status
information and to operate and configure the PowerLoader™.
Figure 3–7. PowerLoader™ Menu
Using the Status Mode
You can enter the Status Mode by pressing the Escape button whenever the Default Screen
displays. Entering the Status Mode does not affect operation of the PowerLoader™. When you
enter the Status Mode, the Status Menu displays:
Figure 3–8. Status Menu
Power-Up Displays
Default Display
Panel Lock
Fault Display
Main Menu
Set Unlock Code
Security Menu
From/To
Flash Update
Park
Reboot Module
NOVRAM Update
Maintenance Menu
Diagnostics
Cartridge Cycle
Friction Test
Tach Feedback
Scanner Feedback
Scan Labels
Clean Drive
Cleaning
Using
Demo Menu
Demo
Demo 2
1
LP-0014
Library Status
Model Number
Firmware Revision
SCSI Bus ID
SCSI Bus Parity
Boot Version
Flash Type
Library Mode
Library Config
Vendor ID
Product ID
Baud Rate
Transport Addr
Storage Addr
Transfer Addr
Import/Export*
Serial Number
Negotiation Mode
Transfer Rate
Unload Mode
Auto Clean Mode
Reserved Slots
Mode Page 1f Length
TUR Reporting
Init Elem Status
Barcode Reader
Label Size
Label Alignment
Loader Status
Abort Move Status
SCSI Mode
Post Recev'd Error
Tape Alert Error
Load/Unload Remove Magazine
Set Mail Slot Code
Configuration Menu
SCSI Options
Library Parity
Library Bus ID
Drive n Bus ID
Vendor ID
Product ID
Negotiation Mode
Transfer Rate
Mode Pg 1F Length
Abort Move Status
Init Elem Status
Init Attn Report
SCSI Mode
Post Recv'd Error
Tape Alert Mode
Library Options Library Options Library Options Library Options
Configuration
Unload Mode
Numbering
Auto Clean
Library Mode
Baud Rate
Reserved Slots
Model Number
Barcode Options Barcode Options Barcode Options Barcode Options
Label Size
Label Alignment
Check Digit
Set Default
Overland Defaults
Compaq Defaults
Set Serial Number
Set Element Base
Transport
Storage
Transfer
Import/Export
Show History Menu
Statistics
Error History
Initial Config
Config History
Show Status Menu
Drive n Status
Tape Motion
SCSI Bus ID
Drive Type
Firmware Revision
Serial Number
IEEE Global ID
Cartridge Present
Cleaning Needed
Write Protected
Cartridge Status
Tape Load Count
Tape Remaining
Map Info
Access Mail Slot
*Displays if Mail Slot enabled
Escape Button
Enter Button
u
u u
u
Access Mail
Library Status
Drive N Status
Map Info
$