oventrop Aktor M, Technical Information, Page: 1 / 6

2017 Oventrop 1
“Aktor M”
Electromotive actuators
Tender specification:
Oventrop electromotive actuators for steady control. The actuator
can be used for two point, three point or proportional control
(0-10 V), with squeeze connection and position feedback signal
0-10 V.
Models: Item no.:
24 V, steady control with 0-10 V 1158010
or switching as two or three point control.
Type of characteristic line
(linear, equal percentage) adjustable.
With enclosed adapter for Oventrop valves.
Same actuator as item no. 1158010
1158011
but without enclosed adapter
Technical data:
Operating current: 24 V ~/=
Power consumption: 4.9 W during operation
8.7 W in final lift position
Drive: 0 - 10 V
Max. piston stroke: 10 mm
Operating power: 500 N
Floating time: 7.5 / 15 s / mm
Protection: IP 54 according to EN 60529
Max. fluid temperature: 120 °C
Ambient temperature: -10 °C up to +55 °C
Storage temperature: -10 °C up to +55 °C
Connecting cable: 5 x 0.5 mm²
Installation:
The connecting cable must not come into contact with the hot pipe
as excessive heat will accelerate the ageing of the cable insulation.
Electrical connection must be carried out in accordance with the
requirements of the local Electricity Board.
The Oventrop electromotive actuators can be installed in any
position, except for vertical downward position.
Depending on the wiring (see connection diagrams), the actuators
item no. 1158010/11 can be used as two point, three point or
0-10 V actuator.
Application:
The actuators can be combined with the following Oventrop
valves:
Item no. 1158010:
“Cocon QTR/QFC” DN 40 and DN 50
Item no. 1158011:
Two-way valves item no. 11308.. and 16708 DN 15-DN 50
Function:
– Synchronous motor with activation and switch off technology
– Electronic recognition of the limit of travel via timer
– Maintenance-free gear with magnetic coupling
– Gear release for manual positioning of the valve. To do so,
activate the lateral sliding switch and set the actuator to the
required position with the help of the enclosed key.
P
M
24 V~/=
MM
02 01
A/D
05
y=0...1
0V
y0=0...1
0V
03
BU BK BN RD GY
MM 02 01
05 03
24 V~/=
open/stop/close
Variante 1 (3pt)
24 V~/=
open / close
Variante 2 (2pt)
5 0 M M 03
BU RD GY
BU BK BN RD GY
02 01
BK BN
Variante 3 (0-10 V)
Connection diagrams item no.1158010/11
Dimensions with mounted adapter
Technical information
157
35
122
126.5
63
43.5
Actuator
Adapter
Variant 1 (3pt)
Variant 2 (2pt)
Variant 3 (0-10 V)